Dranetz Guide Guia do Utilizador descarregar pdf (Página 33)

Dran-View 6 User Guide

Unit Select the basic quantity UNIT of the channel (Volts, Amps,

Watts, etc.)

COMTRADE

Import

Wizard Dialog

Page 1

(Continued)

Enterprise

Edition Only

Characteristics This column defines the characteristics of the channel.

Waveform channels should always be set to “Instantaneous”.

Trend channel should always be set to anything else from the

list, i.e. “RMS”, etc.

This column defines the phase of the channel.

“A”, “B”, “C” Signal measured between

phase and neutral

“AB”, “BC”, “CA” Signal measured between two

phases

“RES” Residual (normally used for

residual current)

“TOT” Total

“NET” Net (normally used for net

current)

“LN-Ave” Line-Neutral Average

“LL-Ave” Line-Line Average

“Worst” Typically denotes the “Worst”

phase

Phase

“1”-“64” 64 arbitrary phases you may

use if the above is not

covering your needs

Measured This column should answer the question “What is

measured?”.

Typically this is “Voltage” or “Current”.

Value Type Choose value type. If you are unsure of what to choose,

“value” is recommended.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 217 218

Sem comentários

Dranetz Guide Guia do Utilizador Página 33