Dranetz Guide Guia do Utilizador descarregar pdf (Página 183)

183

Dran-View 6 User Guide

14.3. Phasor Properties Dialog – General Page

Advanced

Settings

General

Page

The phasor settings are available in two

modes: Basic and Advanced.

The page to the left shows the Advanced

mode.

In this mode three pages are available.

This page also includes all settings on

the General Page. These options are not

listed here.

Parameters Under the "Voltage" option, three radio buttons allow you to

select between data based on line-to-line or line to neutral

wave shapes, if both are available. If you select "Auto" the

measured data is used. The "Power" checkbox will display

phasor arrows for power harmonics.

Harmonic This option will allow you to choose for which harmonic you

wish to display data. In basic mode, FND is always used.

Normalize to

selected harmonic

This option will normalize phase angles to the harmonic

selected in the harmonic combo box of the selected channel.

Include Channel D This option will show a phasor arrow for channel D (if it is

present) in addition to A, B and C, which are always shown.

Show Min/Max

Range

This option will color a pie section of the phasor background

representing the range from the minimum to the maximum

phase angle, if more than one cycle is selected. The phase

arrow always represents the average. The appearance of this

pie section may vary depending on your settings in the

Appearance Page.

Continued on the next page

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 217 218

Sem comentários

Dranetz Guide Guia do Utilizador Página 183