Dranetz Guide Instruções de Operação descarregar pdf (Página 8)

QUICK REFERENCE GUIDE

LPC4300

Page 8

\899036a 4-1-98

SETTING UP THE LOCKABLE PORTABLE CASE

The AC adapter must be installed inside the case prior to mounting the PP4300.

Prepare the case for use as follows. Refer to Figures 1 and 4.

1. Release both latches and open the case. (See note on page 5).

2. Remove the four screws that retain the mounting plate.

Remove the mounting plate.

3. Remove the upper piece of Velcro

from inside the case. Expose the adhesive

backing and attach it to the bottom of the AC adapter. Surface must be clean.

4. Mount the AC adapter inside the bottom of the case as shown in Figure 4.

5. Connect the internal power cable to the AC adapter.

6. Pass the AC adapter output cable through the hole in the mounting plate.

If necessary, remove the grommet and install it after the cable has been

positioned.

7. Install the mounting plate in the case. Be sure the internal cables are not on

top of the mounting brackets. Install and tighten the four screws.

8. Position the PP4300 on the mounting plate as shown. NOTE: Remove the

carrying strap from the PP4300 if installed.

9. Engage the two studs on the back of the PP4300 in the mounting slots in the

mounting plate. Slide the PP4300 forward (toward the case handle) to secure

it to the

mounting

plate.

WARNING

Do not remove mounting plate until all power is de-energized to all circuits.

Figure 4.

Mounting AC

adapter inside case.

4300-114

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Dranetz Guide Instruções de Operação Página 8