Dranetz Xplorer Guia do Utilizador descarregar pdf (Página 234)

C-6

Battery Pack Replacement

Introduction

The PX5 contains an easily replaceable internal battery pack. See Appendix D for

ordering information.

WARNING

Replace with Dranetz

NiMH battery pack BP-PX5 only.

ADVERTENCIA

Reemplace con batería Dranetz NiMH BP-PX5 solamente.

AVERTISSEMENT

Remplacer par la batterie Dranetz NiMH BP-PX5 exclusivement.

WARNUNG

Nur mit Dran

etz NiMH BP-PX5 Batteriesatz auswechseln.

NOTE

During normal operation, the battery pack will be slightly warm to the touch.

Procedure

Follow these steps to replace the battery pack.

Continued on next pa

Step Action

1 Press the PX5 power button to off.

2 Turn off power to the circuit being measured.

3 Disconnect voltage and current probes from the circuit and the PX5’s

rear panel.

4 On the bottom of the PX5, push the tab to release the battery cover. Refer

to the diagram shown on page C-7.

5 Remove the cover.

6 Pull up on removal strap and remove battery pack.

7 Insert the new pack into the compartment making sure to observe

polarity markings.

8 Replace the cover and press down until it latches closed.

9 Discard the old battery pack in accordance with Environmental

Protection Agency (EPA) regulations.

10 Press the PX5 power button to on.

1 2 ... 229 230 231 232 233 234 235 236 237 238 239 ... 289 290

Sem comentários

Dranetz Xplorer Guia do Utilizador Página 234