Dranetz Guide Especificações descarregar pdf (Página 43)

Set Up Communications Options

Communications setting is where you enter instrument-specific information to

enable the Xplorer to communicate to external devices. The available

communications interfaces are: Ethernet, WiFi and Bluetooth. WiFi and

Bluetooth options are standard for the HDPQ Xplorer and Guide. WiFi is

factory installed and not available on the Visa. These communications

interfaces can be used for VNC remote control, remote access by the

Dranetz HDPQ App, and for Modbus TCP.

Ethernet IP connection (Wired) – The Xplorer can be connected to any

Ethernet network (10/100 MBaud Ethernet) using Ethernet/IP software

protocols. The instrument must be connected to the computer network via

the Ethernet cable port. Configurations using the Ethernet/IP protocol require

an IP Address for network communication, and a Gateway address to

effectively communicate with the host device.

Wireless (WiFi) network connection – The wireless network connection

is identical to a standard Ethernet connection, except that it requires a

wireless local area network (WLAN) access point or hotspot based on any of

the 802.11x standards, a wireless network card installed in the Xplorer

(factory-installed at the time of purchase), and a wireless-enabled host

laptop/computer.

Bluetooth connection – The Xplorer requires the addition of a Dranetz

supplied Bluetooth external adapter in order to connect to a wireless-enabled

device using the Bluetooth networking mode. The Bluetooth interface uses a

PAN network that is only available on PC based devices.

VNC connection – The Xplorer can be VNC-enabled so that any VNC

Client can access the instrument remotely, provided the correct password is

entered. Virtual network computing (VNC) software allows you to view and

interact with the Xplorer from any other computer or mobile device anywhere

using the Internet. VNC software is cross-platform, allowing remote screen-

sharing control of the Xplorer. A VNC app or program (not supplied by

Dranetz) is required on your computer, tablet or smartphone for VNC remote

control.

Modbus connection – HDPQ Xplorer can also be connected for real time

measurement reading via the Modbus/TCP protocol.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

Sem comentários

Dranetz Guide Especificações Página 43